The Centre of Pressure Apparatus has been designed to determine the static thrust exerted by a fluid on a submerged surface and allow comparison of the measured magnitude and position of this force with simple theory. A fabricated quadrant is mounted on a balance arm, which pivots on knife-edges. The knife-edges coincide with the centre of arc of the quadrant. Thus, of the hydrostatic forces acting on the quadrant when immersed, only the force on the rectangular end face gives rise to a moment about the knife-edges. The balance arm incorporates a balance pan for the weights supplied and an adjustable counterbalance. This assembly is mounted on top of an acrylic tank, which may be leveled by adjusting screwed feet. An indicator attached to the side of the tank shows when the balance arm is horizontal. Water is admitted to the top of the tank by a flexible tube and may be drained through a cock in the side of the tank. The water level is indicated on a scale on the side of the quadrant.
Title page
Certification
Dedication
Acknowledgement
Abstract
Table of content
CHAPTER ONE
1.0 Introduction
1.1 Background of the study
1.2 Aim of the project
1.3 Objectives of the study
1.4 Scope of the study
1.5 Purpose of the project
1.6 Significance of the study
CHAPTER TWO
Literature review
2.1 Overview of hydrostatic pressure
2.2 Historical background of hydrostatic pressure
2.3 Hydrostatic example (dam)
2.4 Historical usage for sailboats
2.5 Review of movement of center of pressure for aerodynamic fields
CHAPTER THREE
Methodology
3.1 System description
3.2 Equipments and apparatus
3.3 Objectives of the experiment
3.4 Method
3.5 Technical data procedure
CHAPTER FOUR
4.1 Result
4.2 Calculation
CHAPTER FIVE
Conclusion
Development And Calibration Of A Center Of Pressure Apparatus. (n.d.). UniTopics. https://www.unitopics.com/project/material/development-and-calibration-of-a-center-of-pressure-apparatus/
“Development And Calibration Of A Center Of Pressure Apparatus.” UniTopics, https://www.unitopics.com/project/material/development-and-calibration-of-a-center-of-pressure-apparatus/. Accessed 19 September 2024.
“Development And Calibration Of A Center Of Pressure Apparatus.” UniTopics, Accessed September 19, 2024. https://www.unitopics.com/project/material/development-and-calibration-of-a-center-of-pressure-apparatus/
Here’s a typical structure for Development And Calibration Of A Center Of Pressure Apparatus research projects:
- The title page of Development And Calibration Of A Center Of Pressure Apparatus should include the project title, your name, institution, and date.
- The abstract of Development And Calibration Of A Center Of Pressure Apparatus should be a summary of around 150-250 words and should highlight the main objectives, methods, results, and conclusions.
- The introduction of Development And Calibration Of A Center Of Pressure Apparatus should provide the background information, outline the research problem, and state the objectives and significance of the study.
- Review existing research related to Development And Calibration Of A Center Of Pressure Apparatus, identifying gaps the study aims to fill.
- The methodology section of Development And Calibration Of A Center Of Pressure Apparatus should describe the research design, data collection methods, and analytical techniques used.
- Present the findings of the Development And Calibration Of A Center Of Pressure Apparatus research study using tables, charts, and graphs to illustrate key points.
- Interpret Development And Calibration Of A Center Of Pressure Apparatus results, discussing their implications, limitations, and potential areas for future research.
- Summarize the main findings of the Development And Calibration Of A Center Of Pressure Apparatus study and restate its significance.
- List all the sources you cited in Development And Calibration Of A Center Of Pressure Apparatus project, following a specific citation style (e.g., APA, MLA, Chicago).