ABSTRACT
This work is on a zener diode value evaluator, which is used to find the breakdown voltage value of any zener diode. The circuit is divided into two sections: zener evaluator and display unit. Regulated 12V and 5V are required to power the zener evaluator section, while the display section works off only 5V. Connect +5V, point A and ground of the zener evaluator section to the respective terminals of the display section.
This device’s circuit comprises a linear ramp generator built around timer NE555 and an astable multivibrator built around another NE555. The resistor of the monostable is replaced with a constant-current source formed by transistor T1. Capacitor C2 is charged linearly by the constant-current source formed by transistor T1
TABLE OF CONTENTS
COVER PAGE
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWELDGEMENT
ABSTRACT
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE PROJECT
- PURPOSE OF THE PROJECT
- AIM OF THE PROJECT
- OBJECTIVE OF THE PROJECT
- PURPOSE OF THE PROJECT
- LIMITATION OF THE PROJECT
- ADVANTAGES OF THE PROJECT
- PROBLEM OF THE PROJECT
- APPLICATION OF THE PROJECT
- RESEARCH QUESTION
- PROJECT ORGANISATION
CHAPTER TWO
LITERATURE REVIEW
- OVERVIEW OF THE STUDY
- REVIEW OF THE RELATED STUDY
CHAPTER THREE
3.0 CONSTRUCTION METHODOLOGY
3.1 BASIC OF THE SYSTEM
3.2 BLOCK DIAGRAM OF THE SYSTEM
3.3 SYSTEM OPERATION
3.4 CIRCUIT DIAGRAM
3.5 CIRCUIT DESCRIPTION
3.6 DESCRIPTION OF COMPONENTS USED
3.7 POWER SUPPLY UNIT
CHAPTER FOUR
4.0 TESTING AND RESULTS
- CONSTRUCTION PROCEDURE AND TESTING
- INSTALLATION OF THE COMPLET DESIGN
- ASSEMBLING OF SECTIONS
- TESTING OF SYSTEM OPERATION
- COST ANALYSIS
CHAPTER FIVE
- CONCLUSION
- RECOMMENDATION
- REFERENCES
Design And Construction Of A Zener Value Evaluator. (n.d.). UniTopics. https://www.unitopics.com/project/material/design-and-construction-of-a-zener-value-evaluator/
“Design And Construction Of A Zener Value Evaluator.” UniTopics, https://www.unitopics.com/project/material/design-and-construction-of-a-zener-value-evaluator/. Accessed 22 November 2024.
“Design And Construction Of A Zener Value Evaluator.” UniTopics, Accessed November 22, 2024. https://www.unitopics.com/project/material/design-and-construction-of-a-zener-value-evaluator/
Here’s a typical structure for Design And Construction Of A Zener Value Evaluator research projects:
- The title page of Design And Construction Of A Zener Value Evaluator should include the project title, your name, institution, and date.
- The abstract of Design And Construction Of A Zener Value Evaluator should be a summary of around 150-250 words and should highlight the main objectives, methods, results, and conclusions.
- The introduction of Design And Construction Of A Zener Value Evaluator should provide the background information, outline the research problem, and state the objectives and significance of the study.
- Review existing research related to Design And Construction Of A Zener Value Evaluator, identifying gaps the study aims to fill.
- The methodology section of Design And Construction Of A Zener Value Evaluator should describe the research design, data collection methods, and analytical techniques used.
- Present the findings of the Design And Construction Of A Zener Value Evaluator research study using tables, charts, and graphs to illustrate key points.
- Interpret Design And Construction Of A Zener Value Evaluator results, discussing their implications, limitations, and potential areas for future research.
- Summarize the main findings of the Design And Construction Of A Zener Value Evaluator study and restate its significance.
- List all the sources you cited in Design And Construction Of A Zener Value Evaluator project, following a specific citation style (e.g., APA, MLA, Chicago).