ABSTRACT
This circuit lets one to wirelessly control an appliance from a remote place by using a wireless doorbell. The appliance is triggered by the signal from the transmitter of the wireless doorbell and turns off automatically after the preset time period.
The circuit comprises a doorbell (DB1), timer NE555 (IC1) and a few discrete components. The audio output from the battery-powered doorbell receiver is connected to series resistor R1, then AC coupled to the base of npn transistor BC548 (T1) using capacitor C1 and resistor R2. Diode D1 clamps negative excursions of the signal to about 0.6V below ground to prevent damage to transistor T1, which is configured as a common-emitter amplifier with a 4.7-kilo-ohm collector load.
TABLE OF CONTENTS
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWLEDGEMENT
ABSTRACT
TABLE OF CONTENT
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE PROJECT
1.2 AIM OF THE PROJECT
1.3 OBJECTIVE OF THE PROJECT
1.4 SIGNIFICANCE OF THE PROJECT
1.5 PURPOSE OF THE PROJECT
1.6 APPLICATION OF THE PROJECT
1.7 ADVANTAGES OF THE PROJECT
1.8 PROBLEM/LIMITATION OF THE PROJECT
1.9 PROJECT ORGANISATION
CHAPTER TWO
2.0 LITERATURE REVIEW
2.1 REVIEW OF RELATED STUDIES
2.2 REVIEW OF RELATED TERMS
2.3 REVIEW OF WIRELESS TECHNOLOGY
2.4 OVERVIEW OF DOOR BELL
CHAPTER THREE
3.0 CONSTRUCTION METHODOLOGY
3.1 SYSTEM CIRCUIT DIAGRAM
3.2 SYSTEM OPERATION
3.3 CIRCUIT DESCRIPTION
3.4 SYSTEM CIRCUIT DIAGRAM
3.5 CIRCUIT OPERATION
3.6 IMPORTANCE AND FUNCTION OF THE MAJOR COMPONENTS USED IN THIS CIRCUIT
3.7 POWER SUPPLY UNIT
CHAPTER FOUR
RESULT ANALYSIS
4.0 CONSTRUCTION PROCEDURE AND TESTING
4.1 CASING AND PACKAGING
4.2 ASSEMBLING OF SECTIONS
4.3 TESTING
4.4.1 PRE-IMPLEMENTATION TESTING
4.4.2 POST-IMPLEMENTATION TESTING
4.5 RESULT
4.6 COST ANALYSIS
4.7 PROBLEM ENCOUNTERED
CHAPTER FIVE
5.1 CONCLUSION
5.2 RECOMMENDATION
5.3 REFERENCES
Design And Construction Of A Remote Control Using Wireless Doorbell. (n.d.). UniTopics. https://www.unitopics.com/project/material/design-and-construction-of-a-remote-control-using-wireless-doorbell/
“Design And Construction Of A Remote Control Using Wireless Doorbell.” UniTopics, https://www.unitopics.com/project/material/design-and-construction-of-a-remote-control-using-wireless-doorbell/. Accessed 22 November 2024.
“Design And Construction Of A Remote Control Using Wireless Doorbell.” UniTopics, Accessed November 22, 2024. https://www.unitopics.com/project/material/design-and-construction-of-a-remote-control-using-wireless-doorbell/
Here’s a typical structure for Design And Construction Of A Remote Control Using Wireless Doorbell research projects:
- The title page of Design And Construction Of A Remote Control Using Wireless Doorbell should include the project title, your name, institution, and date.
- The abstract of Design And Construction Of A Remote Control Using Wireless Doorbell should be a summary of around 150-250 words and should highlight the main objectives, methods, results, and conclusions.
- The introduction of Design And Construction Of A Remote Control Using Wireless Doorbell should provide the background information, outline the research problem, and state the objectives and significance of the study.
- Review existing research related to Design And Construction Of A Remote Control Using Wireless Doorbell, identifying gaps the study aims to fill.
- The methodology section of Design And Construction Of A Remote Control Using Wireless Doorbell should describe the research design, data collection methods, and analytical techniques used.
- Present the findings of the Design And Construction Of A Remote Control Using Wireless Doorbell research study using tables, charts, and graphs to illustrate key points.
- Interpret Design And Construction Of A Remote Control Using Wireless Doorbell results, discussing their implications, limitations, and potential areas for future research.
- Summarize the main findings of the Design And Construction Of A Remote Control Using Wireless Doorbell study and restate its significance.
- List all the sources you cited in Design And Construction Of A Remote Control Using Wireless Doorbell project, following a specific citation style (e.g., APA, MLA, Chicago).